An Arduino-based subsystem for controlling UAVs through GSM


Long separation and past sight of view correspondence between a ground control station and an Unmanned Aerial Vehicle (UAV) is primarily accomplished utilizing high-gain recieving wires, radio wire trackers or satellites. These usage request costly, overwhelming and not effectively sent gear, while much of the time can’t give an adequate correspondence run. The current work proposes and exhibits a lightweight and ease Arduino-based media transmission subsystem that is fit for sending control directions to the UAV dependent on GSM or GPRS the most broadly sent cell systems standard. Amid field preliminaries control directions effectively exchanged from a cell phone and additionally a PC to the UAV autopilot, with a normal time of 2.6 sec and 0.5 sec individually. The proposed subsystem can be implanted autonomously or exist together with other control frameworks, adding to a pervasive UAVs the board framework.

Leave a Reply

Your email address will not be published. Required fields are marked *