The tilting alteration is accomplished by means of a precise slide that can be set at any coveted edge 45 degrees on either side. The 360-degree swivel base enables the bad habit to be set at any point alongside the vertical hub. The jaws are completely solidified and ground with a parallelism of 0.0012″ (30 microns) the hardness of the jaws is 55 +-HRC. The principal highlights of the tilt and swivel bad habit are advances in large-scale manufacturing, can hold sporadic occupations, greater unbending nature, decreases weariness. Alternate parts were intended to hold the activity in unbending condition. Tilt and swivel bad habit is appropriate for large-scale manufacturing. It is conceivable to hold unpredictable segments likewise, and comparative segments can be rapid.


Tilt and swivel bad habit is one of the cinching gadgets used to hold the activity in inflexible condition. Tilt and swivel bad habit is worked by the offbeat cam component. There is a cam lever, the activity can be held firmly in the middle of the jaws. In this, first the activity is put in the middle of jaws, and portable jaw and mobile jaw is balanced by altering the screw bar to keep up as indicated by the unusualness of the cam with the cam profile. From that point forward, cam lever at the best is worked with the goal that the activity is held firmly in the apparatus.

This sort of installation is helpful for large-scale manufacturing where the just comparable size of employment is to be held. It decreases administrator’s weariness and furthermore diminishes setting time and cost of creation.


The TILT AND SWIVEL VICE is helpful for large-scale manufacturing. It diminishes work weakness and setting time. To hold the activity, in the apparatus, first the activity to be held is put in the middle of jaws. The screw pole is balanced, to hold the workpiece effortlessly. The precise revolution is utilized to bore any edge of turn.

After the activities were done at work, the activity is discharged from the jaws by task sink bar inverse to the heading of locking. At the point when the screw pole is worked to discharge the activity from the jaws, versatile jaw goes in reverse to its unique position. The following occupation is put in the middle of the jaws, and a similar method is rehashed to hold it in the installation.


1. The idle time of the machine is decreased.

2. When contrasted and the mechanical indecencies, it devours less time for clasping and unclamping the activity.

3. It diminishes the hazard to the work

4. Hence, creation rate is higher

5. In this instrument, there is no backfire.


1. Initial higher cost.

2. Hand Operated Vice


1. To hold the activity inflexibly while machining.

2. The angular pivot of the activity is simple.

DOWNLOAD: tilting and swivel vice

Leave a Reply

Your email address will not be published. Required fields are marked *